Communication with PC via a serial port
• Easy to use Windows 98/ME/XP software
• In-circuit/On-board EEPROM programming
• High Speed EEPROM Programming
• CONFIG Register Programming
• Pin tester in both operation modes
• Target MCU baud rate auto detection

• Onboard processor ATmega16 allow to Firmware Update to new versions
• 2 color LED indicates mode of operation, power supply status
• Additional items youll need to use this tool:
1) Host: A 32 Bit x86 based or Pentium PC with a free Com1-8 port or USB port
2) Power supply: An 12 Volt / 500 mA
Supported device table:

MC68HC11  A8 (AB95T)
MC68HC11  A8 (C96N)
MC68HC11  A8 (D26E)
MC68HC11  E20(3E22B)
MC68HC11  E9 (1B60R)
MC68HC11  E9 (D82R)
MC68HC11  E9 (E22B)
MC68HC11  E9 (E28B)
MC68HC11  EA9(2D47J)
MC68HC11  F1 (2F37E)
MC68HC11  F1 (E87J)
MC68HC11  K1 (2D58N)
MC68HC11  K4 (1E62H)
MC68HC11  K4 (OE75J)
MC68HC11  KA4(1E59B)
MC68HC11  KS2(0H95B)
MC68HC11  KS4(0E57S)
MC68HC11  KS4(0F60M)
MC68HC11  P2 (2E74J)
MC68HC711 E20(1H19S)
MC68HC711 E9 (4K81H)
MC68HC711 E9 (5C47M)
MC68HC711 EA9(0D46J)
MC68HC711 K4 (K59D)
MC68HC711 PH8(0H30R)
MC68S711  E9 (5C47M)
XC68HC711 KS8(1H96P)
XC68HC711 P2 (1E53M)